Product Catalogue > Amplifiers > Power-Amplifiers

Ming Da MC34-AB

Product Images

Another product from Ming Da's 2006 range is the MC34-AB. This model showcases the new design approach that you will see in later products. The black double chassis and prominent legs in each corner of the amplifier will be common place in Ming Da's new range.

The MC34-AB's power amplifier section is designed around EIGHT Electro-Harmonix EL34 tubes, producing 75watts in Ultralinear or 40watts in Triode. This is then accompanied by a separate, but built in pre-amp section that utilises 6SN7 and 12AT7 tubes.

The entire amplifier is a dual-mono design, including the power supply which has separate umbilical cords for each channel.

Line-level inputs are located on the side, and the pre-input is positioned at the rear. The external power supply is linked to the amplifier by two shielded locking cables, this insures a low noise environment and a safe connection.

Information about Ming Da

Specifications

• Output Power - 75watts x2 RMS in Ultralinear, 40watts x2 RMS in Triode
• Input Sensitivity - 200mV (Integrated), 1000mV (Power-Amp)
• Output Impedance - 4ohms and 8 ohms
• Total Harmonic Distortion - less then 1%
• Signal-to-Noise Ratio - 93dB
• Frequency Response - 10Hz ~ 60kHz
• Tubes Used - EL34 x8, 6SN7 x2, 12AT7 x2
• Dimensions - 44L x 37W x 23H (cm) Amplifier, 29L x 13W x 14H (cm) Power Supply
• Weight - 35.5kg combined

Features

• External power supply
• Balanced power supply
• Remote control
• 4 selectable inputs
• 1 direct input into power amplifier section
• Switchable between integrated and power amp
• Can be run in either Ultralinear or Triode mode
• Point-to-Point circuitry

Related Products

Ming Da MC34-B $715.00 [More Info...]

Ming Da MC34-A06 $999.00 [More Info...]